1 - 6 of 6 listings
Sort by
Refine
Search results
4
Rust free piece that came off a 1965 Dodge Coronet Drag Car. I bought another and had it put on a 40# diet, cut up for a Charlies Oil Pan, boxed for strength, and powder-coated. When it came in, I swapped this one out for the cut down with QA1 tubula...
Beasley, Texas
Chassis & Under
400.00 Dollar US$
11 months ago
4
One Legger. I pulled this out of a complete axle assembly, which I prepared for a different chunk. Been sitting in my shed for a long time and I'm in clean out mode. Case is grubby and needs cleaning but gears look amazingly good. Most likely should ...
Rosenberg, Texas
Chassis & Under
300.00 Dollar US$
1 year ago
3
I replaced the lower control arms on my 1965 Dodge Coronet Drag Car with tubular. These are in great condition. I'm told that they fit all 1962-1969 Mopar B-Bodies, but please verify they fit your car before buying. They're incredibly heavy, and that...
Rosenberg, Texas
Chassis & Under
150.00 Dollar US$
1 year ago
4
Complete backing plate to backing plate. Housing, axles with lug studs, and center section. Also has brake parts. Backing plate to backing plate measures 55" and Perch to Perch measures 34" meaning the perches were moved the perches inboard. This was...
Rosenberg, Texas
Chassis & Under
700.00 Dollar US$
1 year ago
4
This was a rear axle assembly pulled from my 1960 Plymouth. I drove the car at 75 mph from Little Rock to south of Houston and observed no problems prior to replacing. Complete backing plate to backing plate. Housing, axles with lug studs, and center...
Rosenberg, Texas
Chassis & Under
600.00 Dollar US$
1 year ago
1
I have a pair of used active suspension rear shocks for a 1993 Cadillac Allante. The car had 24000 miles on it when I replace with aftermarket Passive suspension because the "Service Suspension" light was on. There is no aftermarket for these "Active...
Rosenberg, Texas
Chassis & Under
100.00 Dollar US$
1 year ago- 1